The sleek Brivis Contour™ is one of the most advanced Evaporative Coolers in its class, by delivering volumes of refreshing cool air without the large profile of traditional coolers. Designed to consistently deliver clean air, the system’s pre-wet cycle allows for fresh water to enter the cooler and begin soaking the cooling pads before the fan starts.

With applications to suit virtually all types of homes, the Brivis two-piece Wombat range of heaters have up to 3.8 Star energy rating; making it one of the highest rated 3 Star Ducted Gas Heaters on the market.

Compact design for easy installation indoors and in tight spaces. Perfect for new homes, the CC3 is a price concious, no fuss solution that’s easy to install.

The energy efficient Brivis Buffalo 5 star is the perfect solution for replacing or upgrading your existing Buffalo.

Brivis Buffalo external weatherproof units offer greater efficiency and have been reliably keeping Australians warm for over 35 years.

The SP5 Series Ducted Gas Heating System delivers energy efficient heating while using less gas to warm your home.

Compact and affordable, the SP4 Series Ducted Gas Heating System boasts an impressive 4.8 star energy efficiency rating - the highest rated 4 star ducted gas heater in the market.

BRIVIS BLEED TRAY 13mm DRAIN (REPLACES 418)

BRIVIS FAN SD/SENSOR

BRIVIS ELBI BARBED SOLENOID 240V 5.5L\MIN

SNORKEL ASSY BA-F DUMP

Brivis Snorkel Assembly Contour L1 Series

Brivis Snorkel Assembly Advance S5

Brivis Water Sensor Assembly

WATER SENSOR ASSEMBLY - CONTOUR L0

Contour snorkel assembly to suit Brivis models

Suits sump dump supplied with 6mm fitting

Solenoid Valve : Series A 3/4” BSP Inlet (Male) - 3/4” BSP Outlet (Male)

SUITS RED BOX OR CPMD CONTROLS

Rubber stopper (Orange)  20mm hole to suit some Braemar models.

BRIVIS WATER DISTRIBUTOR PIPE ROOF ASSY

BRIVIS IGNITION MODULE LPG, 24V, 50/60Hz

This part allows for the attachment of speed sensors to the motor.

SUITS:N-E1 control box

WALL CONTROL ELECTRONIC PLUS LOOM

This Electronic Controller is a replacement for the N-C1, N-C2 & NC-3

Brivis Electronic Control N-E1 Assembly works with the Manual (Tek 485) & the Networker wall controls.

Replaces control 511, N-E3, N-E4 & N-E5

Replaces N-E3 & N-E5

HCCA6321

Drive arm is connected damper motor assembly via CAM WHEEL (B016077)

Brivis Fan Collet. Replacement part for #B008835

Vibration mount  - Set of 4 (as required in each unit)

533 DIA 5 BLADES 25o PITCH 1/2" AD10-15, AD20-25, SUNDOWNER 4

SUITS: SUNDOWNER 6, AD30, AD31, AD42, AD43, AD52, AD53, AD45, AD55, Contour L30, L40 and L50

Brivis Damper Motor Assembly for Snorkel Drain Valve